The method of connecting the valve on the Hydroflow pipe:

1-putting up pipes to intented direction.

Hydroflow pipe is manufactured frome LD polyethylene materials in 2-20(inch)sizes.

2-connect the pipes to each other.

3-Close the pipe.

4-water flowing in the pipes.

After filling the tubes with water, the holes should be made through punching wherever needed (usually for each furrow).

5-panching holes in the pipes.

Punch about 3-3/5cm above edge line and instal the outlet.

6-insert hydroflow gate.

7-set outlet pipes.

The output of each valve can be adjusted from (zero) liters per minute (fully closed) to 2.5 liters per minute (fully open).

Please note that:

the connections required for the implementation of the Hydroflow irrigation system are end clamps, metal clamps and handles, galvanized,three-way and four-way galvanized connections and air intakes.